New details about the FAA ground stop raise hard questions just days before Thanksgiving travel
The FAA ground stop that halted flights across the U.S. on Friday, Nov. 13, traces back to a new router at an FAA facility in El Dorado, Arkansas. Contractor L3Harris Technologies was there swapping old copper lines for fiber. Officials said the router flooded the network with data and overwhelmed an older system. Five days later, the FAA still has not pinned down a definitive root cause.
The damage was national. Communications and radar feeds failed at 17 of the country’s 22 en route air traffic control centers, and departures stopped for more than four hours. The FAA has paused new installations of the Juniper routers and switched off the ones already in place. For now, the network runs on Cisco routers that have been in service for 25 years.
What caused the FAA ground stop?
The short answer is a flood of traffic. The FAA said the system was hit with about 1,000 connection attempts every four to five seconds, which destabilized radar and aircraft communications. A radar site in Amarillo, Texas, where a router had gone in three weeks earlier, also played a role.
Transportation Secretary Sean Duffy said investigators have recreated the conditions in Arkansas but still lack clarity on the root cause. Hewlett Packard Enterprise, which owns Juniper, said the device worked the way the installer configured it. That wording shifts the spotlight from the hardware to the setup. Officials have found no sign of a cyberattack, and Duffy called claims of a link to new AI tools baseless.
Who signed off before the FAA ground stop hit?
This is where the story gets uncomfortable for Washington. Duffy spent days hammering L3Harris and questioning its competence. The Washington Post then reported that an FAA official was on site in El Dorado, tested the new equipment and approved the job. Communications started failing about eight minutes later.
FAA Administrator Bryan Bedford told reporters on Capitol Hill that an FAA technician monitored the L3Harris engineer during the installation. A source speaking to CNN offered a softer version, saying the FAA worker was mainly there to escort contractors on and off the property. Those two accounts do not line up, and the answer could decide who carries the blame.
Will the FAA ground stop mess with Thanksgiving travel?
Officials say no. Duffy told reporters his own kids fly home from college next Friday and that he expects the system to be fully running for the holiday rush. AAA estimates about 6 million Americans will fly for Thanksgiving, with the Sunday after the holiday expected to be the busiest day.
The stakes are high for families. For a lot of us, Thanksgiving is the one trip home that does not move, and the folks paying for last minute rebookings are rarely the ones writing policy. Bernstein estimated the ground stop cost the four biggest U.S. airlines $345 million. The firm warned that a second outage would hurt more than the first.
Who pays to fix the FAA after the ground stop?
The Trump administration wants $50.1 billion, including $10.1 billion for air traffic control upgrades. Sen. Ted Cruz said he doubts Congress will fund the full amount. Sen. Rick Scott said airlines should pay. Senate Democrats asked for a full halt to new installs and a report on why backup systems failed to stop the meltdown.
Their letter revealed how early this upgrade still is. L3Harris plans to install 3,648 Juniper routers, but only 400 are in and 69 are working. The backup problem has a history too. The last nationwide ground stop, in January 2023, came from a corrupted file that investigators also found in the backup system.
The country is being asked to fund a new system before anyone can explain why the old one failed.